Harpic Power Plus Max: The Ultimate Solution for a Clean, Fresh Toilet
Short on time, big on results. Harpic Power Plus Max is a high-strength toilet cleaner formulated to dissolve limescale, lift stubborn stains and leave your loo smelling fresh. Whether you’re dealing with hard water deposits, brown marks below the waterline or everyday build-up, this thick gel clings to the bowl for a deeper, more hygienic clean.
Why choose Harpic Power Plus Max?
- Heavy-duty limescale removal: Targets the chalky build-up that dulls porcelain and harbours odours.
- Tough on stains: Helps break down rust-coloured rings and below-waterline marks.
- Clinging gel: Thick formula stays where you apply it, including under the rim.
- Fresh finish: Leaves a clean, fresh fragrance after every flush.
Where it works best
Ideal for vitreous china/porcelain toilet bowls and the underside of the rim. It’s not designed for seats, hinges, chrome fittings or natural stone. If in doubt, always check the product label and test on a small, inconspicuous area first.
How to use it (step-by-step)
- Prep: Put on household gloves. Ensure good ventilation.
- Apply: Lift the toilet seat. Angle the nozzle under the rim and squeeze the gel so it coats the sides and flows down into the waterline.
- Wait: Leave to act for up to 10 minutes (or as directed on the label) so the formula can dissolve limescale and break down stains.
- Brush: Scrub thoroughly, paying special attention to under the rim and the outlet.
- Flush: Flush to rinse the bowl clean.
Tip: For heavy limescale, reapply and allow a second contact time. Regular weekly use helps prevent build-up and keeps the bowl brighter for longer.
Pro tips for the best results
- Dry pass first: If the bowl is very soiled, flush once to reduce dilution, then apply the gel to surfaces while they’re less wet.
- Work under the rim: Most build-up hides here—target it with the nozzle and use a curved brush.
- Night treatment: For persistent limescale rings, apply in the evening, allow the label-recommended contact time, brush, then flush in the morning.
- Hard water homes: Increase frequency (e.g., every 2–3 days) to stay ahead of mineral deposits.
Safety & storage
- Wear gloves; avoid contact with skin and eyes.
- Never mix with other cleaning products (especially acids or ammonia). Mixing can release hazardous gases.
- Keep out of reach of children and pets.
- Store upright, tightly closed, in a cool, dry place away from direct sunlight.
Frequently Asked Questions
Does it remove below-waterline stains?
Yes—its thick formula disperses into the waterline. For stubborn marks, let it work for the label-recommended time before brushing.
Can I use it on toilet seats or chrome?
No. It’s designed for the porcelain bowl only. Wipe seats and chrome with a mild, non-corrosive bathroom cleaner.
Is it suitable for septic tanks?
Check the product label for septic-tank guidance. Use as directed and avoid overuse.
How often should I use it?
For hard water or busy households, every 2–3 days; otherwise weekly is usually sufficient to prevent build-up.
Can I leave it longer for extra power?
Only leave for as long as the label advises. Longer contact isn’t always better and may risk surface or fitting damage.
The bottom line
If you’re battling mineral deposits, ring stains or lingering odours, Harpic Power Plus Max delivers a deep, hygienic clean with minimal effort. Use it regularly to protect the shine of your porcelain and keep the bathroom smelling fresh.
